Sue Herrle
- Total activity 8
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 2
Articles
Recent activity by Sue Herrle-
What cable lengths are sold for the cables used to wire the network between DeviceNet Master Units and DeviceNet Slaves?
There are two kinds of DeviceNet Cable: DCA2-5C10 (Thick Cable) and DCN1-5C10 (Thin Cable). These Cables are sold in 100-m increments.
-
Catalog Correction Notice - High-Coded Non-Contact safety Door Switch Datasheet
The mistake of the print and description is found in the catalog that our company issued. We apologize. https://www.ia.omron.com/data_pdf/correct/2021003DE.pdf
-
Is there an instruction that can be used in a subroutine to turn OFF an output bit that was turned ON in the main program?
Yes, the RESET instruction (RSET) or Always OFF Flag can be used in a subroutine to turn OFF a bit that was turned ON in the main program. Using the RESET Instruction (RSET) *A = The output ...
-
Is there a limit to the number of user-defined function blocks and user-defined functions that I can create in an NJ-series Controller?
You can create as many functions and function blocks as you wish as long as the program size is within the program capacity. User-defined functions and user-defined function blocks are included...
-
If I want to run an NJ-series Controller without a battery, can I disable detection of the Low Battery Error, like I can in the Programmable Controller system settings for the CS Series and CJ Series?
No, the NJ-series Controllers are designed to always detect the Low Battery error. When this error occurs, the _RetainFail (Retention Failure Flag) system-defined variable changes to TRUE, and ...
-
Can I connect an NJ-series Controller to an NSJ-series Controller via Ethernet or a serial port?
Yes, you can use either an Ethernet or a serial connection to connect these two Controllers. To use an Ethernet connection, use the EtherNet/IP port. The NSJ-Controller must have an Ethernet po...